Difference between revisions of "SSI-30"

From Stanford SSI Wiki
Jump to navigation Jump to search
Line 17: Line 17:
 
== Pre-Launch ==
 
== Pre-Launch ==
 
[[File:SSI_30_02.jpg | left | thumb | <center> The team</center>]]
 
[[File:SSI_30_02.jpg | left | thumb | <center> The team</center>]]
SSI-28 was part of a combined experimental balloon launch with [[Project UV]], [[Project Sol]], and [[Project X]] designed to provide preliminary data for these research projects.
+
SSI-30 was part of a combined experimental balloon launch with [[Project UV]], [[Project Sol]], and [[Project X]] designed to provide preliminary data for these research projects.
  
 
== Payload Specifications ==
 
== Payload Specifications ==

Revision as of 06:08, 16 February 2016

SSI-30
250px
Designations UV-2, Sol-2, X-2
Launch date February 13, 2016 11:16:34
Launch site Laird Park, Modesto, CA
Launch coordinates 37.56158, -121.14993
Flight duration 3:14:58
Landing coordinates 37.13002,-120.55377
←SSI-29 SSI Balloon Launches SSI-31→


SSI-30 was the 30th launch of the SSI Balloons team and the second launch for the experimental payloads of Project UV, Project Sol, and Project X. It flew 71.30 kilometers over a course of 3 hours, reaching an altitude of 23.59581 Kilometers before landing. It was a complete success, querying ultraviolet A and ultraviolet B concentrations in correlation with altitude, and the concentrations of specific gasses at different altitudes, this time with amplified analog values, and implementing dynamic solar tracking and current data logging, in addition to powering heaters and capturing visuals with a camera.

Pre-Launch

The team

SSI-30 was part of a combined experimental balloon launch with Project UV, Project Sol, and Project X designed to provide preliminary data for these research projects.

Payload Specifications

The Teensy electronics

This payload utilized a Teensy3.2, operational amplifiers, a DC motor, and an H bridge. The teensy measured time, altitude, UV(A) & UV(B) in watts/cm^2, solar luminosity and generated current and voltage, and gas concentrations of Hydrogen, Methane, Carbon Dioxide, Carbon Monoxide, Ozone, and particulate matter. It was also capable of self regulating its temperature, and writing data to an SD card.

Launch site

SSI-30 was launched from a park near Modesto, CA at 11:16AM. The team left campus at 5:30AM, had to correct the current sensor wiring on site, and returned to campus at 11:00AM.

The Flight

SSI-30 was outfitted with a balloon with about .5 net Kg of lift. Due to unforeseen circumstances SSI-29 was also attached to the same balloon. In addition, due to changing winds, the balloon changed direction, lowering the net liniar ground track, traveling 71 Kilometers.

Debriefing

SSI-30 was a success and fulfilled all of the initial goals set out by the team.

  • Successful data collection and logging of Project UV data
  • Successful data collection and logging of Project Sol data
  • Successful data collection and logging of Project X data
  • Successful implementation of a heater control mechanism
  • Successful capture of arial footage
  • Successful landing and recovery

Gallery

Balloon Launches
2014-15 SSI-19202122
2015-16 SSI-23(a) • 2425262728293031323334353637383940414243
2016-17 444546474849505152
2017-18
2018-19 8386879091
2019-20 929397
VE